How to solve if the nozzle is clogged?

13634

2021-11-26

Adventurer 3

Method1: Tap [Preheat] heat up the extruder to 240℃, after heating is completed, press the air tube joint and pull out the filament guide tube. Check whether the filaments are bent or the filament tip is not smooth, cut the tip smooth and flat, Install the guide tube and filament back, Tap [Load].

Method2: If method 1 is not improving, use an unclogging pin tool to unclog filament.

Method3: If method land method 2 not improving, please replace the nozzle.

Here's a video tutorial you may follow to unchocking Adventurer 3 nozzle.

Return To Question List