AD5X Preparation before Printing

Before starting printing, it is recommended to perform the following operations:

1. Clean any residue stuck around the nozzle and any remaining filament on the bed.

2. Apply a thin layer of glue to the build plate. Applying glue helps improve adhesion, resulting in better print quality and facilitating model removal after printing. Specific steps are as follows:

① Take out the glue from the accessory box

② Remove the build plate from the heated bed.

③ Apply a thin layer of glue to the build plate, covering the entire surface evenly.

④ Align the left and right mounting slots carefully and install the build plate back onto the heated bed.